Select(or "pin")measurements and add to takeoff
Once your drawing has Togal.AI data, you can review the measurements and add them to your takeoff. Clicking Togal.AI measurements to select them is called “pinning” them. Togal.AI finds area, length, and count measurements, and each of these is explained below. In some cases, you might need to use a single Togal.AI measurement for multiple takeoffs. For example, a room area trace might be used for the subfloor sheathing, carpet, and baseboard perimeter. You can re-use Togal.AI measurements with different Dimension traces. However, to prevent unintentional duplication of measurements, you cannot use the same Dimension trace for the same Togal.AI measurement multiple times. When necessary, you can use Dimension’s Move/Copy tool to duplicate the measurement.
NOTE: This AI technology is new and rapidly developing. Even when the drawing list shows the drawing as green, you might not see takeoff measurements. If the drawing has no Togal.AI measurements, or very few, it means it was not able to identify any measurements.
Click on the links below for information on Togal.AI different measurement types.
Togal.AI Net Area Measurements
Togal.AI Footprint (exterior wall length and area) measurements