You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.
Home > TogalAI > 05 - Select (or “pin”) measurements and add to takeoff
05 - Select (or “pin”) measurements and add to takeoff
print icon

Select(or "pin")measurements and add to takeoff

Once your drawing has Togal.AI data, you can review the measurements and add them to your takeoff. Clicking Togal.AI measurements to select them is called “pinning” them. Togal.AI finds area, length, and count measurements, and each of these is explained below. In some cases, you might need to use a single Togal.AI measurement for multiple takeoffs. For example, a room area trace might be used for the subfloor sheathing, carpet, and baseboard perimeter. You can re-use Togal.AI measurements with different Dimension traces. However, to prevent unintentional duplication of measurements, you cannot use the same Dimension trace for the same Togal.AI measurement multiple times. When necessary, you can use Dimension’s Move/Copy tool to duplicate the measurement. 

 

NOTE: This AI technology is new and rapidly developing. Even when the drawing list shows the drawing as green, you might not see takeoff measurements. If the drawing has no Togal.AI measurements, or very few, it means it was not able to identify any measurements.

Click on the links below for information on Togal.AI different measurement types.

Togal.AI Net Area Measurements

Togal.AI Length Measurements

Togal.AI Count Measurements

Togal.AI Footprint (exterior wall length and area) measurements

 

Feedback
0 out of 0 found this helpful

scroll to top icon